Windows Application RELEASE version 10.04 - this version supports all Eagle Tree hardware shipped since approximately 2007.

NOTES:

1) OSD Pro, PowerPanel and Seagull users: if you are running Windows software version 8.15 or earlier, upgrading to this version will result in a "factory reset" which will erase all your hardware settings (including RTH settings). Upgrading to a version lower than 8.64 will lose your text on-screen settings. Upgrading to a version greater than 8.64 will lose your text settings, unless you save your configuration (click "Save Configuration" on the setup page for the device).

2) OSD Pro users: if you monitor RSSI, you will need to run the onscreen version of the Servo Analysis wizard, rather than the PC version. This issue will be addressed in the next release version. Guardian stabilization "knob gain" increases to -100%/100% starting with version 10.01 (see manual for more information). Don't forget to save your OSD Pro configuration BEFORE installing new software! If you use the secondary battery voltage monitoring feature, the resistor value required has changed from 10K to 15K starting with software version 9.57

Windows Application BETA version - (no beta version presently available - please use our release version) this version supports all Eagle Tree hardware shipped since approximately 2007.

NOTES:

1) OSD Pro users: Guardian stabilization "knob gain" increases to -100%/100% starting with version 10.01 (see manual for more information). Don't forget to save your OSD Pro configuration BEFORE installing new software! If you use the secondary battery voltage monitoring feature, the resistor value required has changed from 10K to 15K starting with software version 9.57
2) Beta software may be unstable.

Software for Hardware manufactured before approximately 2007

Windows Application "Legacy" version 6.93 - this version supports our eLogger V1 and V2 products, and provides support for Data Recorders and Seagull Dashboards manufactured between 2005 and 2007.

Click here to download Legacy version 6.93.

Windows Application "Legacy" version 5.12- this version supports non-flashable firmware versions of Seagull Flight and Flight Data Recorder V2 (FDR), Seagull Boat and BDR, and Seagull Car and CDR products, (firmware version 3.xx or lower - units shipped from our factory before approximately mid-2005 have non-flashable firmware). To determine your firmware version, click "Tools, Firmware Control" in the Windows Application.

Click here to download Legacy version 5.12.

NOTE: If you have the original Flight Data Recorder, which has a large USB connector and which was discontinued in 2004, please use the CD that came with the recorder.

Click here if you have a non-flashable recorder version, and wish to learn about upgrading the recorder hardware (PDF).